Separate names with a comma.
I'm selling these 2 rails that will fit any of the TS factory stocks. They are made by Peck's Anyware. Rail for bottom of stock, and the...
I don't doubt his knowledge is legit, its just the attitude. Most comments I see that he's made on threads seem to bring up negativity, instead of...
The sh*t show continues. No use arguing with this guy, at some point he will edit or delete your posts. Can't have the administrator looking bad,...
Rattlecan. I do Cerakote too, maybe at a later date I'll re-do it with Cerakote. But the rattlecan was quick and easy.
I doubt I'll ever have a laser on it, but thank you for spending all that time on calculations. Maybe you should get out of the house more.
I will continue to be in awe of your awesomeness.
The stock has no drop, a riser under the sights would be good. I found them a bit low too.
The Aluminum rails are the only thing that are specific to this carbine, and even those can be taken off and sold, and the original rails put back...
Hey, I get it. You are always right, no one should ever dispute what you say.
Flash lights and lasers on carbines and rifles sometimes get used at longer distances than handguns, off set can be an issue.
I did the side rail thing on my Mini-30s, worked out better that way. Flashlight mount on one side, sling mount on the other. For the 4595, I...
Yes, the plastic bottom rail was junk, and sagging down without the FSP. This one is nicely machined aluminum, and doesn't sag. Without the FSP, I...
No, nothing wanky that I notice, but I also saw a degradation in groups with one of my Mini-30s, after changing the flash hider from a long cage...
As it is above, about $770. But I had some of the stuff already from trades or leftover from other builds. HP Carbine---$180 Peck's Anyware...
