Hi-Point Firearms Forums banner

1/8 inch punch

796 Views 3 Replies 4 Participants Last post by  ajole
In the manual that came with my C9 it states that one should use a 1/8th inch punch to drive the pin out. Of the 3 times I have taken the pistol apart, the punch gets stuck and is hard to get back out. Since the pistol is more of a pain to take apart than it needs to be, would it not be better to use a 7/64 inch punch?
1 - 1 of 4 Posts
If you haven’t shot 3000 rounds, you shouldn’t have taken it apart three times…
  • Like
Reactions: 1
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.