Hi-Point Firearms Forums banner
Cancel

1/8 inch punch

797 Views 3 Replies 4 Participants Last post by  ajole, 
M
In the manual that came with my C9 it states that one should use a 1/8th inch punch to drive the pin out. Of the 3 times I have taken the pistol apart, the punch gets stuck and is hard to get back out. Since the pistol is more of a pain to take apart than it needs to be, would it not be better to use a 7/64 inch punch?
Reply
Save
Like
1 - 1 of 4 Posts
lklawson
mouser868 said:
In the manual that came with my C9 it states that one should use a 1/8th inch punch to drive the pin out. Of the 3 times I have taken the pistol apart, the punch gets stuck and is hard to get back out. Since the pistol is more of a pain to take apart than it needs to be, would it not be better to use a 7/64 inch punch?
Click to expand...
Probably.

I try to avoid taking it apart. It doesn't need to be disassembled for cleaning and the resin used seems to wallow out more easily than some others.

Peace favor your sword,
Kirk
Reply
Save
Like
  • Like
Reactions: 1
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Hi-Point Firearms Forums
A forum community dedicated to Hi-point firearm owners and enthusiasts. Come join the discussion about optics, gunsmithing, styles, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
Lounge General Firearms Discussion Hi-Point Carbines Hi-Point Pistols General Hi-Point Discussion
Top