Hi-Point Firearms Forums banner
1 - 14 of 14 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
New member and just picked up a 995 classic. While I was disassembling it yesterday for familiarity purposes I noticed that there is a larger in diameter, shorter spring coil over the firing pin spring. Is this supposes to be so, or did the ejector key spring, which I couldn't find, some how end up there?

Also, I really like the look of the 995 below, this may have been covered in a previous thread but I couldn't find it. Does anyone know where a top rail like that could be found? Is that a heat shield? or did someone just drill into the top of the ATI stock to look like a heat shield?

Thanks

 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top