4595 Last Shot Bolt Hold Open Issue

Discussion in 'Hi-Point Carbines' started by SteelHorse49791, Mar 5, 2016.

  1. SteelHorse49791

    SteelHorse49791 Member

    3
    0
    Greetings,
    My 4595 carbine came with 3 clips. All feed perfectly. However, clip 1 holds the bolt perfectly. Clip 2 only does some times and when it does only a small push on the handle slams the bolt home. Clip3 does not hold the bolt at all.

    All three clips look identical and all three have equal clip follower pressure.

    Any ideas of fixes or do I need to send the carbine with clips back to factory?

    Thanks,
    Ed
     
  2. undeRGRound

    undeRGRound ROLL wif Da MOLE! Supporting Member

    25,156
    1,402
    INDY
    :welcome:steelhorse!!!

    I'd think it could be the mag catch notch in the sides, compare that.
    Sounds like they are going in deeper on some than others... I'd say
    it is where the magazines (clips) are riding in the receiver, most likely.