I was comparing the 995 mag to the Stallard mag; they are very close in height with the 995 mag being a tad bit taller. Since the Stallard mag is kept in place at the heel, it seemed to me that I could slightly modify the 995 mag by cutting a recess for the heel release to fit. After a couple of cuts with a Dremel and a bit of trimming of the 995 mag base, it fits and cycles perfectly. Pics or it didn't happen so here they are: Pic #1 shows at 995 mag alongside the Stallard mag. Pic #2 shows the slight cut in the base of the 995 mag. (Not shown is the corresponding cut in the plastic base plate) Pic #3 is the 995 mag in the Stallard magwell but not fully inserted Pic #4 is the 995 mag fully seated in the Stallard Pic #5 shows how the 995 mag looks in the Stallard.