Hi-Point Firearms Forums banner

995 without a receiver cover

1615 Views 12 Replies 7 Participants Last post by  RACHGIER
I've noticed that the insides of my 995 literally look like the insides of my C9 pistol and it dawned on me that the 995's bolt assembly is just a slide inside a receiver cover and that led me to wonder, could the 995 be safely fired without it's receiver cover and pins? You have the clip holding the "lower receiver" and the firing pin spring holder clip in the rear but would those be enough?


See less See more
1 - 1 of 13 Posts
@Heeroyuy I'm assuming the fact that the pins are 2 of 3 locations to affix the stock to the receiver has completely escaped you?

*Admin Voice* Let's not condone the unsafe operation of a firearm here folks. I've already deleted 1 post.
I was going to but you went all admin. Lol
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.