Hi-Point Firearms Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I bought the gun new about 3 weeks ago and fired it about 2 weeks ago. Shot 250 rounds through it without any complications. I cleaned the gun but did not completely break the gun down because it was no where near the number of rounds that the manual suggested break down for. I went to shoot today and the slide gets stuck when chambering the first 3 -4 rounds, you have to push on the back of the slide to get it to chamber the round. If I only put 4 in the clip it chamber smoothly. Also when I'm chambering the first round it sounds like the springs are catching on each other. Any suggestions?
 

· Registered
Joined
·
210 Posts
Check the feed ramp for build up. I would go ahead and break it down to check the springs and get a really good look at the ramp.

Also check to make sure the mags lips haven't gotten pinched together causing the nose dive.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top