Hi-Point Firearms Forums banner

Banner with R for up?

758 Views 8 Replies 5 Participants Last post by  ajole
I hope this is the right place to post this. I just bought a brand new Bushnell Banner scope, put it on my Ruger American 308. While setting it I noticed the up wasn't there it was an R, the other one on the side also had R like it's supposed to. Seemed Bushnell put the wrong one there. The scope is set and has held zero, has anyone else seen this happen? I contacted Bushnell this morning, they said both adjustment dials are the same size and the scope will be just fine. They said it is still sealed with argon gas and still water and fogproof. Anyone else seen this happen? thanks
  • Wow
Reactions: 1
1 - 3 of 9 Posts
Sounds odd.

Maybe it鈥檚 Raise and Lower? 馃ぃ
Don't have a Bushnell with that incorrect marking, but I do have a CenterPoint that does. They put the U/D marker on the windage knob. Called company, but they didn't have the correct marker to send me at the time. I should call again.
That鈥檚 a left handed scope. Roll it 90 degrees counterclock wise, and that knob will be correct.
  • Like
Reactions: 2
Labels鈥.all the left (handed) cares about anymore馃ぃ
  • Like
Reactions: 1
1 - 3 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top