Hi-Point Firearms Forums banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
9,427 Posts
I've never heard of that hole being stripped out before. I believe there's metal inside the hole that the doll's head drops into, and that metal is going to be a lot harder than the metal in that role pin, so it won't strip out.
 

·
Premium Member
Joined
·
9,427 Posts
@Wiseguy530 Yes it can get wallowed out, which is why they don't recommend a full break/takedown until 3k rounds or more. You're sliding metal through plastic using a punch by repeatedly applying physical force. They also don't recommend switching to an oversized aftermarket screw instead of the factory pin, because you're cutting threads in to plastic and ultimately removing frame material at the rear of the frame at a higher stress point due to the applied forces of recoil.

@Think1st the hole in the frame is all plastic and we had one idiot try to tap the hole for the pin to screw conversion and double down on stupid by going in at an angle, then trying the next size up screw. Never knew what happened to him ... .
Flash photography Eyewear Font Event Monochrome photography
 
1 - 2 of 2 Posts
Top