Hi-Point Firearms Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 · (Edited)
I don't live in a free state so my threaded barrel has been wielded. Can i still field strip this? Can't find a video where the front sight is not removed.

Could I send it to hipoint for a non threaded barrel?

Just trying to figure out my options.
 

·
Administrator
Joined
·
24,380 Posts
I'm assuming you tried to remove your front sight?
 

·
Registered
Joined
·
18 Posts
Discussion Starter · #4 ·

Finally found a video where they dont start with removing the front sight! Hope this helps someone out!
 

·
Administrator
Joined
·
24,380 Posts
For the record, there's no such thing as a field strip on a Hi Point. A field strip is considered a mid- level break down process for maintenance. A Hi Point has no real mid-level break down, unless you consider popping off the cover and pulling it out of the stock as the field strip.

Cleaning them is as simple as snaking the barrel and scrubbing what you can reach until you reach a few thousand rounds before you complete a full break down maintenance service. The carbines are a little easier than the pistols because you can pull them out of the stock and gain a little more access to the internals. And after the first time, I never pulled my front sight again. Just cleaned it on my green gun mat without removing the breech bolt monstrosity.
 
1 - 6 of 6 Posts
Top