Hi-Point Firearms Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
453 Posts
Discussion Starter · #1 ·
Finished my conversion on my Saiga 7.62x39

Before


After




 

·
Registered
Joined
·
453 Posts
Discussion Starter · #4 ·
hehe I didn't even notice the toes in the picture. At least you couldn't see that I wasn't wearing pants :lol:
 

·
Registered
Joined
·
453 Posts
Discussion Starter · #10 ·
Yeah when you move the trigger foward you replace all the trigger parts with aftermarket USA made parts for an AK. I used a tapco G2. The trigger pull is much better than the stock saiga trigger with the weird linkage it uses. The stock I used is just a cheap synthetic stock I got from http://akpartskits.com/store/produc...id=27&osCsid=b630b4d868bde69df787e4efe0c1bd38 . It was sort of shiny when I got it so I took some of the shine off of it with some superfine sandpaper. Oh and thanks for all the kind words.
 

·
Registered
Joined
·
453 Posts
Discussion Starter · #18 ·
On a scale of 1-10 I would rate it a 5. If you are a little bit handy and can use a drill you should have no problem. I too have thought about getting a saiga .308 :twisted:
 
1 - 4 of 4 Posts
Top