firing pin jingle

Discussion in 'Hi-Point Pistols' started by MANINBLU48, Jun 29, 2014.

  1. MANINBLU48

    MANINBLU48 Member

    2
    0
    i took apart c9 to polish feed ramp. after re assembly noticed a noise when gun was moved... i can see thru mag feed the firing pin is moving around along with spring for it, didnt notice noise before. i have no left over parts and have the double spring setup, everything seems to be working fine but havnt fired it yet. is this normal?
     
  2. SWAGA

    SWAGA No longer broke... Lifetime Supporter

    Welcome to the forum.
    Hard to tell what's going on but it sounds normal.
    Did you shoot it yet?
     

  3. ajole

    ajole Supporting Member

    34,662
    11,016
    NE Utah
    That noise is probably the drop safety, they rattle some.
     
  4. MANINBLU48

    MANINBLU48 Member

    2
    0
    I shot before disassembly, not after. The firing pin holds when slide is pulled back. But when firing pin isnt ready to fire it just floats in its channel aling with spring. Didnt notice before disassemble just wanted to be sure before firing