Hi-Point Firearms Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2,817 Posts
Discussion Starter · #1 ·
Got in a new 9mm that was fitted with a ATI Stock that appeared unfired, checked it out and fired about 200 rounds though it with almost no issues. Later when I cleaned the weapon I noticed a heavy coating of grease on the feed ramp. After properly cleaning weapon noticed that rounds would not feed but jam against the ramp. Found a small burr on the ramp that I polished out and now the ramp is smooth as butter but rounds still tend to jam against the ramp. Doesn't matter what mag I load , either stock 10rd or mp 15rd, so don't think that's an issue. Even tryed a light coat of 30 weight motor oil on the feed ramp out of desperation but still tends to jam.

So any suggestions?
 

·
Registered
Joined
·
2,817 Posts
Discussion Starter · #2 ·
One other thing I have a new unmodified 9mm carb coming in the next few days so I can compare the feed ramps.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top