Hi-Point Firearms Forums banner
1 - 20 of 30 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
It would be nice to have Hogue, or some other company, make soft grips for the C-9 and other Hi-Point semi's.
 

·
Premium Member
Joined
·
1,331 Posts
Will the hand-all not fit?
 

·
Registered
Joined
·
4,517 Posts
Leadslinger is 100% right. They do.
 

·
Registered
Joined
·
1,229 Posts
:welcome:

Houge, butlercreek both make a slip on that works very well, some have also used a piece of intertube

Lots to see, do and learn around here and plenty of folks to answear all your hipoint questions. Enjoy :rolleyes2: :yes: :thinking:
But remember

Hipoint the addiction for which there is no cure :evillaugh: :evillaugh: :evillaugh:


Jet
 

·
Village Amadan
Joined
·
593 Posts
...some have also used a piece of intertube
I tried that but got tired of it. :laugh:

:welcome:
 

·
Registered
Joined
·
4,517 Posts
Really like the grips after I out them on my C9 but did not like them on the JHP. Made it too big for my hand and I couldn't hit shat so I took them off. Great on the C9 though.
 

·
Registered
Joined
·
109 Posts
:welcome: Have the handall on my c9 and uncle mikes on my .40. They're both 1000% improvement on the grip. Cost about $10 each.
 

·
Premium Member
Joined
·
503 Posts
Hogue Handall Univ. grip sleeve 17000 fits my .380 perfect, which has the same grip as the C-9.
best 7 bucks i've spent in a long time



Throw it in a bowl of hot water for a few mins, dry it off and it slips right on.
 

·
Registered
Joined
·
17,917 Posts
Moved to Hi-Point Suggestion Zone.
 

·
Premium Member
Joined
·
10,285 Posts
Don't like the Hand-all too bulky for me.Is there any other alternative?
Handall is to bulky?? Just wrap a layer of electrical tape around it then. Than might be thinner. Seriously, The grip is pretty thin. I have torn one all ready. And for around $7 shipped it is hard to beat.
 

·
Premium Member
Joined
·
36,070 Posts
I liked the Handall on my JCP, but the bulges made mu C9 feel wrong, so I went Handall Jr on it.

Another option, is the Hogue Tool grips! I put them on the C9-COMP and the 995, just to be perverse...they feel thinner, and work great. They are fun colors too, so they go well with the whole 'Battery pack" image. Just remember to use ammonia, like the instructions say, and they'll slide right on.

Tool Grip Site
 

·
Registered
Joined
·
2,623 Posts
I just got the Handall today and put it on my 380. I do have an issue with it though, it doesnt fit quite right on the back of the gun handle. Its bunched up in back. Any suggestions?
 
1 - 20 of 30 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top