Mount for Red Dot/Laser to Clear Iron Sights

Discussion in 'Hi-Point Carbines' started by c9-old-rookie, Mar 26, 2016.

  1. c9-old-rookie

    c9-old-rookie Member

    19
    0
    Hello, guys. Anyone know of a source for a mounting attachment to go on the top rail of the 995TS that will permit mounting my Red Dot, allowing me to still use stock iron sights???

    Don't know what to call this thing I need, probably some special term that I've not learned yet.... :rolleyes:
     
  2. Rachgier

    Rachgier Administrator Staff Member

    They sell a side rail kit for the carbines. Not sure if you were aware of that.
     

  3. c9-old-rookie

    c9-old-rookie Member

    19
    0
    Who "they", Bob ??
    I wasn't aware.
     
  4. Rachgier

    Rachgier Administrator Staff Member

    Sorry, a bit vague wasn't I? HP sells a rail kit on their accessories page. It's the same plastic as the top rail.

    It's solid enough for a laser and flash light.

    Now as far as your RDS is concerned, you might have a length issue depending on the length of your optic. I chopped the frame of my stock rear iron to make room and did a lower 1/3 co witness which allowed me to use both sights.

    What type of RDS are you planning on using, if I might ask? It will help us figure out a solution.
     
  5. undeRGRound

    undeRGRound ROLL wif Da MOLE! Supporting Member

    25,156
    1,408
    INDY
    Even a bit cryptic at times :D