Hi-Point Firearms Forums banner
1 - 1 of 1 Posts

· Premium Member
Joined
·
2,398 Posts
my KT's balk a bit after 50-100 rounds, IMO because they are built to tighter tolerances and the dirt accumulated after firing that many rounds, will probably cause some malfunction.

If at that time you clean them up, they will continue to perform until more gunk gets accumulated. Next time at the range, wipe them down and lube them again and I'll bet it will start working properly.

Good luck!
Interesting. I've put 200 rounds through my P3AT at one session and 250 through my PF-9. I know a lot of people claim the recoil is too harsh for that, but I disagree. Both were working fine at the end of that number of rounds. I've always wondered if KelTec, admittedly a fairly small company, has some variance in their manufacturing tolerances that allows these different experiences from people.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top