Hi-Point Firearms Forums banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
10,385 Posts
Discussion Starter · #1 ·
I'm about to buy these to put on my Taurus
http://www.cheaperthandirt.com/46042-1.html

Can anybody out there tell me how to do this. I know there is a set screw in the sights. But how do I get the sights out of the little groove?

These are dovetail sights if that helps.
 

·
Registered
Joined
·
128 Posts
i put those same sights on my taurus mil pro...after you loosen the set screw i used a small punch and lightly tapped them out. mine had what looked like a drop of silicon helping to hold the original sights in.
 

·
Premium Member
Joined
·
935 Posts
Loosen the screws and then use a small brass or hard plastic punch and a rubber or brass mallet. A few light taps should do the trick.


Ron M.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top