Seriously, that is the only real flaw to the Hi Point set up, the firing pin acts as the ejector, and it is a full length exposure when it does, so any empty casing that catches funny on the way out and has to be pushed out hard is liable to bend the pin.
Not that big a deal, just get a couple of spares and they are very easy to change out, or like another poster said, you can bend them straight again and keep firing them.
Just make sure you get it good and straight because otherwise it will start making the firing pin hole in the slide bigger every time it forces its way through the hole
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.