Hi-Point Firearms Forums banner
1 - 11 of 11 Posts

·
Premium Member
Joined
·
258 Posts
Discussion Starter · #1 ·
Just wondered if anyone here has replaced the 995 picatinny rail with the replacement rail from Bushman?........It definately appears to be a must have, and I was wondering if you use the same mounting screws as on the factory one? It just appears from the pic that it may be thicker and they need to screw into the 2 small rectangular plates under the shroud. Any reply on this will be much appreciated.Thank you all! :cool2:
 

·
Registered
Joined
·
11 Posts
Bushmans rails are drilled and countersunk to accept the original Hi Point hardware and the full rail has a countersunk hole at the end with a supplied #8 allen screw.
That's a great pic. What did you do to "blacken" the rail? Do you have to drill the front hole in the ATI stock for the long rail?

Thanks.
 

·
Banned
Joined
·
6,069 Posts
Iowatriker a forum member can make about any muzzle brake you need.
I got my top & bottom rails from a guy on E-bay called hartstool?
 

·
Premium Member
Joined
·
36,165 Posts
Will the Bushman picatinney rail fit without modification to the 995TS?

Where can you purchase the Bushman?
You can't, he quit doing it.
And no, they fit the ATI, not the classic or TS.
 
1 - 11 of 11 Posts
Top