Discussion in 'Vintage Topic Archive (Sept - 2009)' started by beretta92_fs200, Dec 23, 2007.

  1. I'm going to ploish my barrel and feed ramps what grit sandpaper should I use to do this right?
  2. hpman

    hpman Guest

    I used a dremel tool with a buffing wheel to polish. Not sure the grit of sandpaper probably 150 or so.

  3. Mike_AZ

    Mike_AZ U.S.S. Member

    I would use something a lot finer than 150 grit. I too used a dremel, polishing wheel and automotive rubbing compound. Her is someone who used sandpaper.

  4. The biggest I would personaly use is about 2000 grit. It will take a bit but you will come up with a nice shine
  5. rodka

    rodka Member

    i used a lower grit paper to remove the paint and stuff quickly then i used a fine grit to polish. took about 20 minutes