Sighting in my carbine

Discussion in 'Hi-Point Carbines' started by OkSlim, Mar 23, 2016.

  1. OkSlim

    OkSlim Member

    Finally got the chance to sight in my 4595TS.

    I had to adjust the rear peep sight way to the right.

    Should I adjust the front sight more to the right so the rear is more in the middle.

    The TruGlo cowitnesses perfectly.

    Wound up shooting about 75 rounds to get it where I wanted at 50 yards.

    The sights were set about 6" low and 6" left at 25 yards from the factory

    Carrying it to and from the house to the target range, I did figure out, I need to figure out some kind of single point sling.

    Of course, I had the JHP in the drop holster and had to burn a few mags through it before I came in.
     
    Last edited: Mar 23, 2016
  2. TNTRAILERTRASH

    TNTRAILERTRASH Supporting Member

    I have a 995TS I bought used that has a bent rear sight. Seller neglected to point that out. He did admit to it later. I have a spare sight. Just lazy.

    For a single point I am thinking about a big carabiner clip.
     

  3. ajole

    ajole Supporting Member

    34,512
    10,741
    NE Utah
    Sometimes, the front sight can be slightly canted, you loosen the set screws, make it straight, and re-tighten.;)
     
  4. TNTRAILERTRASH

    TNTRAILERTRASH Supporting Member

    Probably take a C-clamp and clamp a straight edge on it and adjust accordingly.
     
  5. ajole

    ajole Supporting Member

    34,512
    10,741
    NE Utah
    I just swapped the HP sling swivel to the left side, and clipped right into that.

    [​IMG]
     
  6. Mediocre_Bob

    Mediocre_Bob Supporting Member

    293
    101

    Ditto. Works great.
     
  7. TNTRAILERTRASH

    TNTRAILERTRASH Supporting Member

    All this time here and never saw that mentioned. I saw other ways of doing it! Duh!

    :rofl:
     
  8. ajole

    ajole Supporting Member

    34,512
    10,741
    NE Utah