Hi-Point Firearms Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
586 Posts
Discussion Starter · #1 ·
problems with a taurus 1911.

slide sometimes doesn't fully cycle back, small gap in the ejection port (about a millimeter) and isn't closing properly, any ideas?
 

·
Village Amadan
Joined
·
591 Posts
When you pull the slide back is the round fully seated into the face of the bolt and locked in with the extractor?
 

·
Premium Member
Joined
·
935 Posts
Clean and lube slide rails with a Lithium grease.

What type/brand of ammo are you using? I would suspect a weak loading if your gun is clean and lubed correctly. If you are using hand loads the cases may not have sized correctly.

Ron M.
 

·
Banned
Joined
·
19,442 Posts
also possible kinked recoil spring, jammed extractor, or there could bea burr or nick on the chamber mouth impeding things going where they need to. detail strip and clean, carefully inspect and retest with known good ammo.

SW
 
1 - 4 of 4 Posts
Top