Hi-Point Firearms Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
105 Posts
The thought of hammering away on my gun to tear it down disturbs me, I spray gun scrubber in it after a good bore cleaning.
Taking the slide off only requires the removal of one pin and that comes out easily. I left the barrel on and put blue painters tape over everything that I didn't want polishing chunks to get into.

Is there a way to polish the ramp without using a dremel?
I think in another thread someone mentioned that they did it by hand using fine grit sandpaper.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top